5-1
Basic Product Specification
Notes*1: The details are described in chapter 4.
*2: The actual scanning speed might differ due to host computers’ environment.
*3: The maximum number will differ due to the paper thickness. Refer to chapter 4.
*4: The scanning speed might be slow. The usage with NO COMPRESSION is recommended.
*5: Both SCSI-2 and the Third Party Slot can not be used at the same time.
*6: The Power consumption of the boards should be as follows:
- In the Low Power Mode: Less than 0.35 A
- With IPC-4D option: Less than 1.5 A
- Without IPC-4D option: Less than 3.0 A
N
o
.
Item Specification Remarks
1 Operating method ADF (Duplex), Flatbed
2 Image sensor CCD x2 Front/Back
3 Light source Inert Gas (Xenon) Lamp x2 Green
4
Document
Size
Minimum A8 (Portrait)
Maximum A3/11 x 17 in.
5 Document Thickness 52 g/m
2
(14lb) to 127 g/m
2
(34lb) Note *1
6 Optical Resolution 400 dpi
7
Output
Resolution *5
Binary 100/150/200/240/300/400/600 dpi
Grayscale
100/150/200/240/300/400 dpi Simplex
100/150/200 dpi Duplex
8 Grayscale level (internal) 1024 levels (10bit)
9
Scanning
Speed
(Engine Speed)
Note *2
Simplex
55ppm, 200dpi, A4, Portrait
35ppm, 300dpi, A4, Portrait
45ppm, 300dpi, A4, Landscape
Duplex
100ipm, 200dpi, A4, Portrait
60ipm, 300dpi, A4, Portrait
80ipm, 300dpi, A4, Landscape
10 Halftone patterns Dither/ Error diffusion
11 Capacity of ADF 250 sheets (A4, 64 g/m
2
(17lb)) Note *3
12 Compression MH/MR/MMR Note *4
13
Interface
Note *5
SCSI-2
High Density
50-pin, Female
Third Party Slot Note *6
