Fujitsu M4000/M5000 Manual

A SERVICE OF

next previous

SPARC Enterprise M4000/M5000 Servers Product Notes 11

AttachingEndCapstotheRails

Aftersecurin gthecablemanagementarm(CMA)totheSPA RC Enterprise

M4000/M5000server,attachtheprovidedendcapsto therails.

1. SecuretheCMAtotheserver.

RefertotheEquipment RackMountingGuideforin formati ononinstallingtheCM Ato

theserver.

2. Attachtheend capsontothesliderails.

For

theSPARCEnterpriseM4000server,anendcapisattached toboththerightand

leftrearrails(

FIGURE 1).

FortheSPARCEnterpriseM5000server,twoendcapsareattached totherailson

whichtheCMAisnot att ached (

FIGURE 2).

Note – IftheCMAisnotused,attachallendcapstotherailsoftheserver.The

SPA RC EnterpriseM4000serverusestwoendcap s. Th eSPARCEnterpriseM5000

serverusesfourendcaps.

FIGURE 1 InstallingEndCapsontheSPARCEnterpriseM4000SlideRails