3-21
3
Using the NI / 5E Custom Terminal Set-Up
At the conclusion of selecting buttons for Call
Announce Intercom, this screen appears:
SUPPORTED (SELECT/ALL)
COMPLETED
1. Press ENTER. If one or two way intercom is
enabled, the screen displays the enabled mode
plus the authorized DN, as shown below:
TWO WAY TURNED ON
919*926*3112
If no telephone numbers have been programmed
in, the Call Announce Intercom feature is disabled,
and the screen displays NON SUPPORTED:
INTERCOM FEATURE (1)
NON SUPPORTED
To program the first number and enable Call
Announce Intercom, go to step 2.
2.
ENTER
1: ONE WAY2: TWO WAY
3: TURN OFF(SELECT 1-3)
1: ONE WAY - speaker is activated on the
recipient’s set, but the microphone is off.
2: TWO WAY - both speaker and microphone
are active.
3: TURN OFF - intercom feature is disabled.
3. Press 1 or 2, then ENTER. A screen appears
showing your choice and prompting for an
authorized DN:
TWO WAY SELECTED (1)
ENTER TELEPHONE NUMBER
