Customer ServiceTroubleshooting TipsOperating InstructionsSafety Information
11
Display What It Means What To Do
Drain is blocked. This Locate and remove the blockage in
indicates that the drain the drain system.
WASH
is so clogged that the
1
Check the air gap (see the Air
LIGHT
dishwasher cannot
Gap section).
FLASHING
continue to operate in
2
Check for a kink in the drain hose.
a satisfactory manner.
Dishwasher will stop.
3
Check for stopped-up drains.
(
NOTE:
Warranty service does not
cover household drain problems.)
To pump any remaining water out of
the machine:
1
Latch door.
2
Touch
RESET
. Select desired cycles
and then touch
START
and
RESET
again.
Not enough water is Unlatch the door. If there is no water
entering the dishwasher. in the bottom of the dishwasher, check
RINSE
the water supply to the dishwasher.
LIGHT
•
Is the dishwasher water supply turned
FLASHING
on? (Valve usually located under the
sink.)
•
Is the household water supply
turned on?
•
If you use well or cistern water, is the
supply adequate?
Press the
RESET
pad. If the water
supply is adequate, try the cycle
again. Ifthe
RINSE
light flashes
again, call for service.
■ Try the cycle again to see if the light flashes again. The
dishwasher may correct itself.
■ Electronic controls can be affected by outside interference.
■ Sometimes shutting off power to the dishwasher (at the fuse or
circuit breaker) could correct the problem. Restore power after
15 seconds and try the cycle again.
■ Check the guide for things you can do to correct the problem.
■ See the
Before you call for service
section at the back of this manual.
Before You Call For Service
