Creating Bends
Note:The method for creating a specific radius is
a trial-and-error process. Due to the many varia-
tions among metal workpieces, no single position-
ing will create the same curve on all materials. We
recommend using scrap pieces the same dimen-
sions and material as your final workpiece until the
desired curve is achieved.
Figure 17.
To create a bend in a workpiece:
1.
Figure 17
2.
Figure 15
Figure 15.
Figure 16.
3.
Figure 16
4.
Steps 23
The main rollers of this
machine present a pinch-
ing hazard. Make sure no
body part or clothing is
near the area between the
rollers. Failure to follow this
warning may result in fin-
gers, hair, or clothing being
pulled into the machine,
causing personal injury.
