5.
Figure 24
Figure 24.
6.
Mounting a Chuck or Faceplate
1.
2.
3.
4.
5.
Note: Attempting to overtighten the chuck
or faceplate will make removal difficult and
could damage the threads.
6.
Note: Make sure the spindle clamp tangs
properly fit into the spindle groove before
tightening the set screw (see Figure 22
7.
Make sure the chuck or
faceplate is firmly secure
on the spindle and remove
the chuck key. Object
thrown from the lathe
could cause serious per-
sonal injury or death to
the operator or bystand-
ers.
Mounting a
Workpiece
