4
The assembled cleaner will look like this
drawing.
1-2
Attach upper handle
Remove clean solution tank (upper tank)
from deep cleaner.
With cord hook (B) to back of deep cleaner,
push upper handle down onto lower
handle.
1-3
1-6
1-7
1-4 1-5
1 - 8
1 - 9
Push b o l t s into holes on front of handle. If
bolts will not go through hole easily,
handle is not pushed completely down.
A
C
B
Place nuts in recessed areas on back
of handle. Hold each nut in place while
tightening each bolt securely with a
Phillips screwdriver. Only two nuts are
needed on this model. The extra nut is
not required, but has been provided for
your convenience.
When handle sections are completely
together, squeeze trigger (C) on upper
handle to snap trigger rod in place.
Replace clean solution tank (upper tank)
by positioning bottom first. Press on tank
handle (D) to snap top of tank into
place.
Press cord into cord clip on back of
handle. Pull cord tight.
D
Remove nozzle stored on upper handle
by gently pushing nozzle downward
while pivoting it away from the handle at
(A).
