A SERVICE OF

logo

1. Feed the controller cable through the cable guide on the chair, and then through the front of the power panel.
2. Connect the controller cable connector to the corresponding connector on the chair.
3. Secure the controller cord to the chair cable harness in the same location in which it was secured previously, using a new zip tie.
4. Replace the two screws to secure the controller cord to the outside of the power panel.
5. Place the power panel into position, then replace the five screws to secure the power panel to the chair.
6. Replace the five rubber inserts to cover the five screw heads.
7. Plug in the chair, power it on, then verify that the chair is working properly.
INSTALLING THE NEW CONTROLLER
2
Please send any questions or comments regarding these instructions to: documentation@humantouch.com
© 2012 Human Touch
®
, LLC.