7
42798-01 • 09/16/09 • Hunter Fan Company
7
CAUTION:
e motor cover
adapter has a
special coating
on the threads.
Do not remove
this coating; the
coating prevents
the pipe/ball
assembly from
unscrewing. Once
assembled, do not
remove the pipe/
ball assembly.
3 • Assembling and Hanging the Fan
7
7
8
3
2
3
3
4
4
8
79
79
3.2
3.4
3.1
3.3
Insert the pipe/ball assembly (7) through the ceiling mounting plate cover
(3) and ceiling mounting plate cover trim ring (4). Feed the wires from the
fan through the pipe/ball assembly (7).
Use the Allen wrench (79) to securely retighten the setscrew (8).
Raise the fan and align the slots in the ceiling mounting plate cover (3)
with the hooks on the ceiling mounting plate (2). Note: To hang the fan,
you must tilt the ceiling mounting plate cover (3) to an almost vertical
position so that the ceiling mounting plate cover (3) slots sit on the ceiling
mounting plate hooks.
Using the provided Allen wrench (79), loosen the setscrew (8) on the
motor cover adapter to install the pipe and ball assembly (7). When the
pipe and ball assembly (7)is fully installed, 2-3 threads on the pipe will still
be visible; this is normal.
