11
Insignia NS-R2001 AM/FM Stereo Receiver
www.insigniaproducts.com
Using the sleep timer
The sleep timer automatically turns the receiver off
after a specified period of time.
To use the sleep timer:
• Press the SLEEP button to specify the amount of
time you want the receiver to play.
Each time this button is pressed, the time
changes as follows:
•10 minutes
•20 minutes
•30 minutes
•60 minutes
•90 minutes
•OFF
Adjusting the display brightness
To adjust the display brightness:
• Press the DIMMER button to specify the
brightness of the display.
Each time this button is pressed, the brightness
changes as follows:
•ON
• dimmer
•OFF
Maintaining
To clean this receiver, wipe with a soft, dry cloth. If
the surfaces are extremely dirty, use a soft cloth
dipped in a soap and water solution or a weak
detergent solution.
• Never use alcohol, paint thinner, or benzine to
clean this receiver.
• Before using a chemically treated cloth, read the
instructions that came with the cloth carefully.
Troubleshooting
If a problem occurs, run through the table below
before contacting Insignia.
If the problem persists, attempt to solve it by
switching the receiver off and on again. If this fails
to resolve the problem, contact Insignia. Under no
circumstances should you attempt to repair the
receiver yourself as this could void the warranty.
Note
While operating the sleep timer, the lights up.
Note
If the display is off, pressing any button turns the
display on.
Category Problem Possible Solution
No power
• The AC power cord is
disconnected.
•Poor connection at AC
wall outlet or the outlet
is inactive.
• Connect the cord securely.
• Check the outlet using a lamp or
another appliance.
No sound
• The speaker cords are
disconnected.
• The volume is adjusted
too low.
•The MUTE button on the
remote control is pressed
to ON.
• Speakers are not
switched on.
• Incorrect selection of the
input source.
• Incorrect connections
between the
components.
• Check the speaker connections.
•Adjust the volume.
• Press the MUTE button to cancel
the muting effect.
• Turn on one or both speakers.
• Select the desired input source
correctly.
• Make connections correctly.
Stations cannot
be received
• No antenna is connected.
• The desired station
frequency is not tuned in.
• The antenna is in wrong
position.
• Connect an antenna.
• Tune in the desired station
frequency.
• Move the antenna and retry
tuning.
Preset stations
cannot be
received
•An incorrect station
frequency has been
memorized.
• The memorized stations
are cleared.
• Memorize the correct station
frequency.
• Memorize the stations again.
Poor FM
reception
• No antenna is connected.
• The antenna is not
positioned for the best
reception.
• Connect an antenna.
• Change the position of the
antenna.
NS-R2001_10-0038_MAN_ENG.book Page 11 Wednesday, February 3, 2010 7:36 AM
