11
Scalding Hazard: The faucet dispenses near-boiling
(212ºF) water which can instantly cause scalds or
burns. Use care when operating this appliance.
Property Damage: Join remaining tube
to cold water supply only.
Property Damage: Join remaining tube
to cold water supply only.
B
■■
Turn on the cold water supply.
■■ Depress
the dispenser’s HOT handle
and hold it until water flows from
the spout (approximately 1 to 2 minutes).
■■
Run the water for at least 2 minutes to
flush lines (both the hot and cold handles
independently if applicable).
A
A
6
■■
Check all connections to ensure they are
tight
and that there are no leaks.
■■
Plug in instant hot water tank.
Water will be cold at first.
Allow 12-15 minutes for water to reach
target temperature.
Gurgling or hissing is normal during the
initial heating cycle.
5
■■
Install a T-fitting (not included) onto the
cold water supply line.
■■
Install dedicated water control valve with
3/8" compression fitting.
■■
At the end of the white 3/8" tube from the
quick-connector, slide the supplied brass
nut and ferrule over the tube and then push
in the brass tube insert.
■■
Insert the white 3/8" tube into the 3/8"
compression fitting and tighten.
HC-View/HC-Wave/HC3
■■
Install a T-fitting (not included) onto the
cold water supply line.
■■
Install dedicated water control valve with
1/4" compression fitting (not included).
■■
At the end of the copper 1/4" tube,
slide the brass nut and ferrule provided
with the control valve over the tube.
■■
Insert the copper tube into the 1/4"
compression fitting and tighten.
H-View/H-Wave/GN3/H990/H770
A
Property Damage: A standard grounded outlet within
30" of the dispenser is required under the sink. Do
not use an extension cord set with the dispenser.
