FASTENERS / LOADS
FASTENERS / LOADS
7
Your Ramset Model 721 tool uses only the Ramset fasteners and loads
shown below or listed for the tool in the Product Catalog .
DANGER
.300 HEAD PLASTIC FLUTED DRIVE PINS
.300 HEAD PLASTIC FLUTED DRIVE
PINS WITH 7/8" WASHER
1/4"-20 Threaded studs
.300 HEAD TOP-HAT DRIVE PINS
.300 HEAD POWER POINT
PLASTIC FLUTED DRIVE PINS
CONDUIT CLIP ASEMBLIES
For 1/2" and 3/4” Diameter Conduit with
1" premounted fastener
CEILING CLIP ASSEMBLIES
Ceiling Clip with 1" or 1-1/4" premounted
.145 shank pin and Ceiling Clip with 1" or
1-1/4" premounted .150/.180 shank pin.
Never use any other types of fasteners or loads in the Model 721 tool.
Use of other types of fasteners or loads may cause unintentional load discharge,
damage the tool, cause poor fastening performance, or create a risk of serious
injury to the operator or bystanders.
FASTENERS
.145 Shank Diameter in Shank lengths from
1/2” to 1 1/2”
.145 Shank Diameter in Shank Lengths from
1” to 2”
.145 Shank Diameter in Shank Lengths of
1/2” and 1” and thread lengths of 1/2”, 3/4”
and 1”. Maximum overall fastener length is
1 1/2”for the Model 721 tool .
.150 Straight Shank in Shank Lengths from
1/2” to 7/8”
.150 / .180 Step Shank in Lengths from
1” to 1 1/4”
.145 Shank Diameter in Shank Lengths from
1/2” to 1”
LOADS
POWER CATALOG LOAD CASE
LEVEL NUMBER COLOR COLOR
1 12 CW Gray Brass
2 22 CW Brown Brass
3 32 CW Green Brass
4 42 CW Yellow Brass
The power level of the loads is indicated by
the number marked on each box, the color of
the box and the color on the tip of each load.
As the number increases, the power level
also increases.
Always perform the center punch test
described on page 3 to test the base
material.
Always make a test fastening using the #1,
Gray, power level first. If more power is
required to set the fastener, use the next
higher power level until the power level
necessary to drive the fastener is reached.
Ramset .22 cal. CW loads are specially made for use in the Model 721 Tool.
RAMSET CW LOAD
