EN 45
EDITING
MasterPage: Start_Right
ADVANCED FEATURES
The audio track can be customized only when
recorded in the 12-BIT and SP modes.
(੬ pg. 33)
●
Use the provided remote control.
1 Play back the tape to locate the point where
editing will start, then press PAUSE (8).
2 While holding A. DUB ( ) on the remote
control, press PAUSE (8). The “8 ” indicator
appears.
3 Press PLAY (3), then begin “narrating”.
Speak into the microphone.
●
To pause dubbing, press PAUSE (8).
4 To end Audio Dubbing, press PAUSE (8),
then STOP (7).
To hear the dubbed sound during playback
Set “NARRATION” to “ON” or “MIX”
(੬ pg. 35).
NOTES:
● Sound is not heard from the speaker during
Audio Dubbing.
● When editing onto a tape that was recorded at
12-BIT, the old and new soundtracks are
recorded separately.
● If feedback or howling occurs during TV
playback, move the camcorder’s microphone
away from the TV, or turn down the TV’s volume.
You can record a new scene into a previously
recorded tape, replacing a section of the
original recording with minimal picture
distortion at the in and out points. The original
audio remains unchanged.
●
Use the provided remote control.
NOTES:
● Before performing the following steps, make
sure that “TIME CODE” for “DISPLAY” in both
Recording and Playback Menus is set to “ON”.
(
੬ pg. 34, 35)
● Insert Editing is not possible on a tape recorded
in the LP mode or on a blank portion of a tape.
1 Play back the tape, locate the Edit-Out point
and press PAUSE (8). Confirm the time code
at this point. (੬ pg. 20)
2 Press REW (1) until the Edit-In point is
located, then press PAUSE (8).
3 Press and hold INSERT ( ) on the remote
control, then press PAUSE (8). The “8 ”
indicator and the Time Code (min.:sec.)
appear and the camcorder enters Insert-Pause
mode.
4 Press START/STOP to begin editing.
●
Confirm the insert at the time code you checked
in step 1.
● To pause editing, press START/STOP. Press it
again to resume editing.
5 To end Insert Editing, press START/STOP,
then STOP (7) on the remote control.
NOTES:
● Program AE, Effects and Shutter Effects
(
੬ pg. 41) can be used to spice up the scenes
being edited during Insert Editing.
● During Insert Editing, the date and time
information changes.
● If you perform Insert Editing onto a blank space
on the tape, the audio and video may be
disrupted. Make sure you only edit recorded
areas.
● During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Editing stops.
Audio Dubbing
PAUSE
PLAY
A.DUB
STOP
REW
INSERT
START/
STOP
Speaker
Stereo
Microphone
Insert Editing
GR-D790US.book Page 45 Friday, December 15, 2006 9:26 AM
