10. TIME CODE OPERATION
E-64
10-1 Displaying Time Code
The GY-DV5000 records EBU-standard time codes and user’s bits. In the play mode or the record mode, the reproduced time
codes or user’s bits are shown on the LCD monitor or in the viewfinder.
● Time code data cannot be output through the unit’s connectors.
OPEN
CH-1
AUDIO INPUT
AUDIO SELECT
CH-2
CH-1 CH-2
FRONT
REAR
AUTO
MANUAL
AUDIO
LEVEL
CH-1 CH-2
PULL
OPEN
LCDBRIGHT DISPLAY
COUNTER
CH-1
AUDIO INPUT
AUDIO SELECT
CH-2
CH-1 CH-2
FRONT
REAR
AUTO
MANUAL
TC GENE.
TC
MONITOR
SELECT
AUDIO
LEVEL
AUDIO INPUT
CH-1 CH-2
CH-1
MIX
CH-2
FRONT REAR
LINE
MIC
+48V
PRST
REGEN FREE
REC
UB
LCD BRIGHT DISPLAY
OPEN
CH-1
AUDIO INPUT
AUDIO SELECT
CH-2
CH-1 CH-2
FRONT
REAR
AUTO
MANUAL
AUDIO
LEVEL
CH-1 CH-2
PULL
OPEN
LCDBRIGHT DISPLAY
COUNTER
CH-1
AUDIO INPUT
AUDIO SELECT
CH-2
CH-1 CH-2
FRONT
REAR
AUTO
MANUAL
TC GENE.
TC
MONITOR
SELECT
AUDIO
LEVEL
AUDIO INPUT
CH-1 CH-2
CH-1
MIX
CH-2
FRONT REAR
LINE
MIC
+48V
PRST
REGEN FREE
REC
UB
LCD BRIGHT DISPLAY
00:00:00:00
STBY 01/02/03 01:23:45
––– TC/UB/CLOCK –––
TC PRESET 00:00:00:00
EXECUTE
TC CLEAR CANCEL
UB PRESET 00 00 00 00
EXECUTE
UB CLEAR CANCEL
UB REC ON
TIME/DATE..
PAGE BACK
HEADER REC..
The time codes or user’s bits can be shown on the LCD monitor
or in the viewfinder during playback and recording as follows.
(Status screen)
Setting
1.
Set the TC/UB item on the LCD/VF (2/2) menu screen to
ON.
● Time codes or user’s bit data are displayed on the Status
screen.
2.
Whether time codes or user’s bit data should be displayed
is selected with the COUNTER switch inside the cover on
the side.
TC : Time codes are displayed.
UB : User’s bit data is displayed.
COUNTER switch
Time code indication
Status 1 screen
10-2 Presetting and Recording of Time Code
To preset the Time Code, make the following settings.
■ TC GENE. switch
Set to PRST REC or PRST FREE.
PRST REC : The data preset in the time code generator
runs only during recording.
Use this setting if it is necessary to record
continual time codes across different
scenes.
* However, approximately ±1-frame
variations may occur in scene accuracy.
PRST FREE : The time code starts to run from the time it
is preset in the time code generator.
Example
Time code indication
00:00:00:00
User’s bits indication
FF EE DD 20
TC GENE. switch
TC/UB/CLOCK menu screen
The time codes from the internal time code generator can be recorded at the time of recording scenes.
Whether or not user’s bit data should be recorded can be selected with the UB REC item on the TC/UB/CLOCK menu screen.
