EN
19
Turn on the VCR and the TV, and select the AV
mode on the TV.
DBS RECEIVER SET UP
OFF
PRESS (
2
3
), THEN (OK)
PRESS (MENU) TO END
Setting DBS receiver output
channel & brand
After installation, set the DBS receiver’s output channel
and its brand correctly; otherwise, the Controller cannot
work correctly.
1
Turn on DBS receiver
Select a channel other than channel 55, 100 or
205 on your DBS receiver.
2
Access Main Menu screen on VCR
Press MENU.
3
Access Tuner Set Up screen
Press %fi to move the highlight bar (arrow) to
“TUNER SET UP”, then press OK.
4
Access DBS Receiver Set screen
Press %fi to move the
highlight bar (arrow) to
“DBS RECEIVER SET
UP”, then press OK.
5
Select DBS receiver output channel
Your selection depends on how your DBS
receiver is connected to your VCR.
● If your DBS receiver
is connected to your
VCR’s ANTENNA IN
terminal on the rear
panel
Press
@
#
until the
channel number
representing the DBS
receiver’s output (CH3 or CH4) appears on the
screen.
● If your DBS receiver is connected to your VCR’s
AUDIO/VIDEO IN connectors on the front panel
Press
@
#
until “ON F-1 (FRONT)” appears on
the screen.
● If your DBS receiver is connected to your VCR’s
AUDIO/VIDEO IN (L-1) or AUDIO/VIDEO IN
(L-2) connectors on the rear panel
Press
@
#
until “ON L-1 (REAR)” or “ON L-2
(REAR)” appears on the screen.
● If you do not use a DBS receiver
Press
@
#
until “OFF” appears on the screen.
CONTINUED ON NEXT PAGE \
123
456
7
89
0
VCR TV CABLE/DBS
2
3 4
3 4
TUNER SET UP
BAND CATV
AUTO CHANNEL SET UP
MANUAL CHANNEL SET
GUIDE CHANNEL SET
CABLE BOX SET UP
3
DBS RECEIVER SET UP
PRESS (5∞), THEN (OK)
PRESS (MENU) TO END
5
