10
Setup
Mounting hood cover (provided)
1 Align the hood cover with the groove on top of the
viewfinder screen and insert from the top.
2 Secure with the screw found under the center of the
viewfinder screen.
1 To adjust the angle of the viewfinder, loosen the Pan/
Tilt Lock Handle and secure it at an appropriate angle
for visible viewing.
Note：
● The LCD screen may be difficult to see depending on the
view angle. Use the angle right in front of the screen.
1 When setting the POWER switch on remote control
or camera to AONB, image will be output on the
viewfinder.
Note：
● Depending on the system environment, it may take up to 40
seconds before the image is output.
1 Turn the [BRIGHT] control to adjust the
brightness of the screen.
To brighten, turn to the right.
Caution：
● If the [BRIGHT] control is turned completely to the left,
images may not be output.
2 Turn the [CONTRAST] control to adjust the
contrast of the screen.
To increase the contrast, turn to the right.
3 Turn the [PEAKING] control to adjust the peaking.
To sharpen the contour, turn to the right.
Note：
● Yo u can adjust the freqency band where the contour is
emphasized with the [PEAKING] control under the
[PEAKING FREQ.] item of the [SHOOTING ASSIST] menu
screen. (A Page 14)
Caution：
● After the power switch of the camera or the remote control
unit is turned off, wait for 10 seconds and above to turn on
the switch again.
● Turning ON/OFF the power switch quickly may cause
malfunction.
Installation (continued)
Adjusting position
Screw
Panning
Tilt
Panning and Tilt Lock Handle
Outputting images
Adjusting picture quality
MENU
STATUS
BRIGHT
CONTRAST
PEAKING
1:1
FOCUS
ASSIST
5
6
4
5
6
4
[BRIGHT] control
[CONTRAST] control
[PEAKING] control
VF-HP840U_EN.book Page 10 Thursday, January 17, 2008 2:48 PM
