64
CALL SCAN
You can alternate between monitoring the Call Channel
and the current operating frequency.
1 Select the frequency (in VFO or Memory Recall
Mode) you want to monitor.
• In VFO Mode, turn the Tuning control to select the
desired frequency.
• In Memory Recall Mode, turn the Tuning control to
select the memory channel you want to monitor.
2 Press [CALL] (1 s) to start the Call Scan.
3 The Call Channel and the selected VFO frequency or
memory channel are monitored.
4 To stop Call Scan, press [PTT] or [CALL].
Note:
◆ You must configure the CALL key function to “CALL” (Menu No.
18) prior to using Call Scan. Otherwise, a 1750 Hz tone will be
transmitted.
◆ The transceiver stops scanning when it detects a signal.
◆ You can perform Call Scan even if the recalled memory channel
has been locked out {page 67}.
