English
|
27
DVD Setup Menu features
Test tone
This item allows you to adjust the output level of
each channels of speaker using the built-in test
signal. The output level must be adjusted from
the listening position.
1 Select "SPEAKER SETUP" page
See 'DVD setup mode' (page 23) to select
"SPEAKER SETUP".
2 Selects the "TEST TONE" signal output
Select "TEST TONE" and press the [ENTER/£]
button.
3 Sets the "TEST TONE" output
Press the [5], [∞], [2] or [3] button to select
an item.
Press the [ENTER/£] button.
Display Setting
"ON" Outputs the test tone (noise signals).
"OFF" Stops to output the test tone.
4 Adjusts the sound level of each speaker
See the 'Audio Control' section (page 11) and
adjust each speaker to output the same level of
sounds.
5 Turns the Test tone off
Select "OFF" and press the [ENTER/£]
button.
6 Exit Setup page
Select "MAIN PAGE" and press the [ENTER/£]
button.
"TEST TONE"
See 'Test tone', page 27.
3 Exit Setup page
Select "MAIN PAGE" and press the [ENTER/£]
button.
• When you set the "DOWNMIX" to "LT/RT" or "STEREO,"
you cannot set any parameter other than "DOWNMIX."
• The "LARGE" or "SMALL" setup of "FRONT," "CENTER"
and "REAR" items corrects the bass during playback of
Dolby Digital sound.
• You can select the "SMALL" of "FRONT" item only
when you have set the "SUBWOOFER" item to
"PRESENT."
