73
ENG
ENGLISH
MAKING CONNECTIONS
RGB Connection
Transmits the analog video signal from your PC to
the TV. Connect the PC and the TV with the D-sub
15 pin signal cable as shown in the following
illustrations. To transmit an audio signal, connect
an audio cable.
ABLE IN
RS-232C IN
CONTROL & SERVICE)
GB IN (PC)
DI
IN
RGB/DVI
PTICA
DIGITA
UDIO OUT
DVI IN
IDE
DI
MONO
IDEO
UDI
COMPONENT I
V IN
P
ANTENNA IN
CABLE IN
RS-232C IN
(CONTROL & SERVICE)
OPTICAL
DIGITAL
AUDIO OUT
/DVI IN
2
1
2
1
VIDEO
AUDIO
L(MONO)
R
VIDEO
AUDIO
COMPONENT IN
AV IN 1
Y PB PR
RL
RGB IN (PC)
AUDIO IN
(RGB/DVI)
RGB OUT (PC)
AUDIO OUT
RGB IN (PC)
AUDIO IN
(RGB/DVI)
NOTE
To get the best picture quality, adjust the PC
graphics card to 1024x768.
Depending on the graphics card, DOS mode
may not work if a HDMI to DVI Cable is in
use.
In PC mode, there may be noise associated
with the resolution, vertical pattern, contrast
or brightness.
If noise is present, change the PC output to
another resolution, change the refresh rate
to another rate or adjust the brightness and
contrast on the PICTURE menu until the
picture is clear.
Avoid keeping a fixed image on the screen
for a long period of time. The fixed image
may become permanently imprinted on the
screen.
The synchronization input form for Horizontal
and Vertical frequencies is separate.
Depending on the graphics card, some
resolution settings may not allow the image
to be positioned on the screen properly.
When selecting HDMI-PC, set the “Input
Label - PC” in the
INPUT
menu.
