A SERVICE OF

logo

Optional Equipment (for qualified installers only) 33
Travis Industries 100-01142 4050114
LP Conversion Instructions
Install the conversion kit prior to installing the gas line to ensure proper gas use.
1 Remove the glass (see page 19). Remove the log set (if installed - page 21)
2 Remove the burner (see illustration below).
Remove the two ember trays on each side of the
burner. Reach into the firebox and lift the left side of
the burner upwards and slide it to the left.
Slide the air shutters all the way to the
right before installing the burner.
Make sure the mixing tube
slides onto the orifice.
Burner Replacement:
Make sure this pin inserts into the
hole in the bottom of the burner
and theburner is fully seated.
Mixing Tube
Orifice
Do not lift the burner from the pins.
Ember Trays
NOTE: the pilot hood may interfere with the burner
during removal. You can remove the burner hood by
pulling up on it until it detaches (see the illustration on
the following page).