Check these }oints if ,our washer...
IZ
• Unevenly distributed load. Redistribute the load, close the lid and pull knob
out. Check for leveling. Be sure water level is acceptable for load size.
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Turn the control knob to proper cycle and pull knob out to start the washer. If
Stops equipped with buttons, be sure they are fully depressed.
• Close lid and pull knob out to start the washer. For your safety, washer will
not agitate or spin unless lid is closed.
• This may be a pause or soak period in the cycle. Wait briefly and it may start.
• The washer is equipped with a lid switch failure detector. If the lid switch
should malfunction, the detector will stop fill operations for your safety. Call
for service.
• * • • • * • ., • .. .. • • • • •• .. • ...• • .. . .* • • • * .. * ** * .. * ** * * • .* •
• Make sure hose connections are tight.
Leaks Water • Make sure end of drain hose is correctly inserted and secured to drain facility.
• Avoid extended soaking - soak for 30 minutes or less.
• Avoid overloading.
• Be sure washer is leveled properly as outlined in installation manual.
ls Noisy • Weak floors can cause vibration and walking.
• Be sure rubber feet are installed on leveling legs.
• •..•.. •• • .• • .. • • •, . • • • • • • • • *• • .. • • • * • • • •• • .. * •. • .. ••. . • •* . •,
• Turn both faucets on fully.
• If equipped with a temperature selector knob, be sure it is set directly on a
Fills with temperature setting and not between settings.
the Wrong • Make sure temperature selection is correct.
Temperature • Make sure hoses are connected to correct faucets and inlet connections. Be
Water sure water supply is regulated correctly. Flush water line before filling
washer,
• Check the water heater. It should be set to deliver a minimum 120°F (49°C)
hot water at the tap. Also check water heater capacity and recovery rate.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• ... • .* • •• • .. • . • • • • .. • .* • .. • .. • • • • • .. • • • •
Cycle Selector
Knob Advances • Extra rinse option is selected
Through "OFF"
• • .. • .. • .. • • • • • .• • .. • = • • • .. •. .. . .• • • • ..• •.• • • • ¢ • • • • •. • .. • •
Forfurther help, call Maytag CustomerAssistance: U,S. 1-800.688.9900 or Canada 1-800-688-2002
U.S. customers using TTYfor deaf, hearing impaired or speech impaired, call 1.800-688-2080.
10
