•Never leave the appliance connected and un-
attended if is not in use. This saves energy
and prolongs the life of the appliance.
•Do not use the appliance on any part of the
body of a person or animal.
•Do not use the appliance to dry textiles of any
kind.
•CAUTION: Do not leave this appliance unat-
tended if it is switched on.
•Turning the thermostat control to the minimum
(MIN) setting does not mean that the iron is
switched off permanently.
Service:
•Make sure that the appliance is serviced only
by specialist personnel, and that only original
spare parts or accessories are used to replace
existing parts/accessories.
•Any misuse or failure to follow the instructions
for use renders the guarantee and the manu-
facturer’s liability null and void.
Instructions for use
Before use:
Remove the appliance’s protective film.
•Make sure that all the product’s packaging
has been removed.
•Some parts of the appliance have been lightly
greased.
•Consequently, the first time the appliance is
used a light smoke may be detected.
•Prepare the appliance according to the func-
tion you wish to use.
Filling with water:
•It is essential to have filled the deposit with wa-
ter to be able to work with steam.
•Open the lid of the filling mouth.
•Fill the deposit taking care to observe the MAX
level(Fig. 1)
•Close the lid of the filling mouth.
Use:
•Unroll the cable completely before plugging it
in.
•Connect the appliance to the mains.
•Turn the thermostat control to the desired tem-
perature position.
•Do not use temperatures higher than those in-
dicated on the garments to be treated.
Setting Type of textile
•
Synthetics, Nylon, Acrylics,
Polyester, Rayon
•• Wool, Silk
••• Cotton, Linen
MAX
Linen
•If garment has various kinds of fibres, select
the temperature for the fibre that requires the
lowest temperature.
•(For example, select the temperature for poly-
ester for an article made out of 60% polyester
and 40% cotton).
•Wait until the pilot light (F) has gone out which
will indicate that the appliance has reached an
adequate temperature.
•During use the pilot light (F) will automatically
flash on and off, thus indicating that the heat-
ing elements are operating in order to main-
tain the desired temperature.
Dry ironing:
•The appliance has a steam flow regulator
that permits dry ironing (without steam) when
placed in the 0 position.
Steam Ironing:
•It is possible to iron with steam whenever the
deposit is filled with water and the adequate
temperature is selected.
Steam flow control:
•The appliance has a (C) control knob that al-
lows to get the control of the steam flow.
Spray:
•The spray can be used in both steam and dry
ironing.
•Press the spray button ( A ) to use this opera-
tion.
•The spray button has to be pressed repeat-
edly to release the first spray.
Steam blast:
•This function proportions extra steam for elimi-
nating wrinkles.
•Press the steam blast button (B). Wait a few
seconds until vapour penetrates the fibres of
the garment before pushing the button again.
•For optimum steam quality, do not apply more
23260_IM.indd 4 2013/08/26 10:06:48 AM
