Preparing the furniture front
^
Open the appliance door as far as it
will go.
^ Unscrew the installation aids n and
angle trim o from the door.
^ Put the angle trim o and screws in a
safe place - they will be required
later.
^ Take the cover off the light contact
switch.
^ Close the appliance door.
^ Measure gap X between the
adjusting bar and the upper edge of
the adjacent furniture front.
^ Remove the two nuts from the
appliance door, and place them in a
safe place - they will be required
later.
^ Place the furniture front on a firm
surface, with the external side facing
downwards (place on a blanket or
similar to avoid it becoming
scratched).
Installation
55
