A SERVICE OF

logo

Open as PDF
next previous
5 - 74
MELSEC-
A
5 DATA USED FOR POSITIONING CONTROL
Da.13
Parameter
Set the value as required for "
Da.12 Special start command".
Da.12
Special start command
Setting value Setting details
Block start (Normal start) – Not used. (There is no need to set.)
Condition start
1 to 10
Set the condition data No. (No. of
"condition data" set to perform
condition judgement)
(For details of the condition data, refer
to Section 5.5.)
Wait start
Simultaneous start
Stop – Not used. (There is no need to set.)
Repeated start (FOR loop) 0 to 255 Set the No. of repetitions.
Repeated start (FOR condition) 1 to 10
Set the condition data No. (No. of
"condition data" set to perform
condition judgement)
(For details of the condition data, refer
to Section 5.5.)