TV + antenna or cable without a
decoder box (cont.)
_Important:
_Important:
_Important:
procedure
(See illustration on the following page.)
O Connect the incoming cable or antenna to the ANTENNA IN
terminal on the VCR.
O Connect one end of a coaxial cable to the ANTENNA OUT
terminal on the VCR.
Connect the other end of the coaxial cable to the ANT-A
terminal on the TV.
O Connect an RCA pin-type video cable to the VIDEO OUT
terminal on the back of the VCR. Connect the other end of this
cable to the VIDEO INPUT terminal on the back of the
television.
If you are connecting a Super VHS (S-VHS) VCR, _ise an S-Video
cable instead of an RCA pin-type video cable. Connect this S-Video
cable to the S-VIDEO OUT terminal on the VCR. Connect the other
end of this cable to the S-VIDEO INPUT terminal on the back of
the TV.
O Connect a set of RCA pin-type audio cables to the AUDIO OUT
terminals on the back of the VCR. Use the red cable to connect
the right (R) channel and the white cable to connect the left (L)
channel.
O Connect the other ends of these cables to the AUDIO INPUT
terminals on the back of the TV.
If your VCR is monaural (non-stereo), you only need to connect a
single RCA pin-type audio cable. Connect the cabl_ to the VCR,
then connect the other end of the cable to the L (LEFT) audio input
on the back of the TV.
If your VCR has a video channel switch, set it to "OFF/AV." See
your VCR's owner's guide for details.
Start playing a tape on your VCR.
O Use the INPUT button on your TV_s remote cc,ntrol to select
Input-1.
32 Chapter 2: Connecting Your TV
