A SERVICE OF

logo

Open as PDF
next previous
219
CHAPTER 4 FUNCTIONS
4
4.14 Sensor Correction Function
● If a write data error (error code: 7
H
) occurs during sensor two-point correction, correctly configure the setting for
sensor two-point correction again. (The value set for sensor two-point correction of when an error occurred is not written
in the Q64TCN.)
● To use the value set for sensor two-point correction even after the power is turned off and on or the CPU module is reset
and the reset is cancelled, back up the value with the following method.
• Turn off and on E
2
PROM backup instruction (Yn8). ( Page 57, Section 3.3.3 (4))