20
HOOK-UP GUIDE
Remote “DC In” Control Hook-Up
This feature connects your PowerSource to an automated Home Theater control system or allows another component
with a Remote “DC Out” connection to automatically turn on and off your PowerSource.
A) Plug the AC power cable of the component you are using to control the PowerSource into
an unswitched outlet on the PowerSource. Note: This component must deliver a control voltage
between 3-30 volts DC.
B) Plug one end of the 1/8" miniplug (supplied) into the corresponding Remote “DC In”
connection on the PowerSource.
C) Plug the other end of the 1/8" miniplug into the Remote “DC Out” connection on the
component that you want to turn on and off the PowerSource’s Switched Outlets when
it is turned on.
Remote “AC In” Control Hook-Up
This feature connects your PowerSource to an automated Home Theater control system or allows another
component with an AC outlet connection (for example, an AV receiver or preamplifier for example) to automatically
turn on and off your PowerSource.
A) Insert the Remote “AC IN” Control cord’s female plug into the “AC IN” 120V connection.
B) Insert the Remote “AC IN” Control cord’s 2-prong male plug into a switched AC power outlet
on the component (AV receiver or preamplifier). When this device is turned on, the outlets
programmed as “Switched On” on the PowerSource will turn on immediately. The outlets
programmed as “Switched On After Delay” will turn on after the set time delay.
Ê
ÎHÎä6
Ê
££ä6
