1. Installation and Quick Start
4
1.4 Recording paper
A Open the top cover by pressing the top cover release
button (1).
B Install the recording paper.
C Insert the leading edge of the paper into the opening
above the thermal head (1).
D Pull the paper out of the unit.
L Make sure that there is no slack in the paper roll.
E Close the top cover securely by pushing down on
both sides.
F For KX-FT932:
Press {FAX/START}, then tear off the excess paper
by pulling it towards you.
For KX-FT934:
Press {FAX/START} to cut the paper.
Quick Start
1.5 Fax sending / Copying
A Open the document feeder tray.
Correct
Incorrect
1
1
Note:
L If the paper is secured with glue or tape, cut
approximately 15 cm from the beginning of the roll
before installing it.
L When the power cord is connected, a message is
printed each time the top cover is opened then
closed. If the recording paper is installed upside
down, the message will not be printed. Install the
paper correctly.
L For accessory information, see page 3.
FAX/START
{FAX/START}
FT932_934HK-PFQX2561YA-en.book Page 4 Monday, May 8, 2006 5:05 PM
