61
SETUP PROCEDURES
■ Setup Procedures
This unit has two setting procedures.
The one is SETUP MENU, which is the unit's on-screen dis-
play (OSD).
The other is WJ-SX150A Administrator Console, which
operates on the PC.
• SETUP MENU (OSD)
The basic functions, which are essential for the operation,
are configurable. However, some items are not config-
urable. The settings about group sequences, operators and
schedules, etc.
• WJ-SX150A Administrator Console (PC)
All the functions of this unit (except camera manual clean-
ing) are configurable. You need a PC to use WJ-SX150A
Administrator Console.
Refer to p. 79 WJ-SX150A ADMINISTRATOR CONSOLE for
details on the platform and installation.
Notes:
• The Master unit administrates all the system settings.
Do the setup procedure with the Master unit only.
• To use WJ-SX150A Administrator Console, you need to
prepare a PC and a 9-pin D-sub cable.(Refer to p. 48.)
• When changing the configuration of WJ-SX150A
Administrator Console, configuration data getting and
putting are necessary between the unit and PC to acti-
vate your configuration.
■ Description of Setup Procedures
This chapter describes about configurable items.
● Master-Slave Connection Settings
Both SETUP MENU and WJ-SX150 Administrator console
can configure the parameters of master-slave connection
and logical camera number.
• Master-slave: The composition of the master-slave con-
nection is configurable.
• Logical camera number: Logical camera number,
which is used for camera control and monitor display,
can be assigned to each camera.
● Sequence Settings
SETUP MENU can configure tour sequences. WJ-SX150A
Administrator Console can configure both of tour
sequences and group sequences.
• Tour sequence: Up to 32 tour sequences are config-
urable (64 steps per tour).
• Group sequence: Tour sequences can be activated on
up to 4 monitors simultaneously (1 tour sequence per
monitor).
● Schedule Settings
SETUP MENU can configure daylight saving time. WJ-
SX150A Administrator Console can configure timer event,
camera cleaning, and daylight saving time.
• Timer event: A sequence or spot mode can be activat-
ed on the regular time of every month, week or day.
Up to 50 timer events can be registered.
• Camera cleaning: Camera cleaning can be executed
on the regular time of every month, week or day.
• Daylight saving time: Daylight saving time schedule for
20 years are configurable.
display pattern.
communication speed (baud rate) of the ports Data 1 to 4.
