39
ENGLISH
Using the REMOTE 2 terminal provided on the side of the
main unit, it is possible to operate the projector from a
control panel etc. furnished in a distant location where
infrared remote control signal cannot be received.
Pin assignments and control
Be sure to short-circuit Pins and
when controlling.
Using the REMOTE 2 terminal
•
The following buttons on the remote
control and the operation area of the
projector can no longer be operated when
pins and are shorted: POWER
button and SHUTTER button.
Neither will it be possible to use the
RS232C commands or network functions
corresponding to these functions.
•
If you short pin and pin , and also
short one of the pins from to and
pin , then the following buttons on the
projector operating area and the remote
control can no longer be operated:
POWER, RGB1, RGB2, DVI, VIDEO, S-
VIDEO and SHUTTER buttons.
Neither will it be possible to use the
RS232C commands or network functions
corresponding to these functions.
Note
Cable specifications
Control commands
When controlling the projector from a computer, the
following commands are available:
• To connect the computer to the
SERIAL terminal, prepare an
adequate communication cable that
fits to your personal computer.
Attention
