46
Insert the power cord plug into the wall outlet and then
press the MAIN POWER switch.
Press the “POWER” button (or the POWER OFF ( I )
button on the remote control) so that a picture is
projected onto the screen.
Press the “MENU” button to display the MENU screen,
and then press the and buttons to move the
cursor to select “OPTION2”.
Press the “ENTER” button to display the “OPTION2”
screen, and select “SYSTEM INFORMATION” with the
and buttons.
Press the “ENTER” button.
The SYSTEM INFORMATION screen will be displayed.
Press and hold the “ENTER” button on the projector or
the remote control for approximately 3 seconds.
An item “LAMP TIME RESET” will be added.
Press the ENTER button, and when the “LAMP TIME
RESET” display flashes, press the ENTER button again.
The used hours of the lamp unit will be reset to zero.
• If the power does not turn on even after turning the MAIN
POWER switch “I”, turn the MAIN POWER “O”, confirm that
the lamp unit and door are installed correctly, and turn on
again.
Attention
