ENGLISH - 43
Settings
PROJECTOR SETUP menu
You can see the status of the projector about the
following items.
You can switch the function of the COMPUTER2 IN/
1OUT terminal.
INPUT COMPUTER2 IN
OUTPUT COMPUTER1 OUT
You can set the timer to switch off the power of the
projector after a certain period of time automatically
when no signal is detected. Press I H to select the
required period from 15 to 60 minutes at intervals of
5 minutes.
You can select how the projector start when the mains
lead is connected.
STATUS
Items Description
Q SIGNAL
NAME Projecting signal name
FREQUENCY Projecting signal frequency
Q RUNTIME
PROJECTOR Duration of projector used time
LAMP Duration of lamp used time
Q REMAINING FILTER
QUANTITY Quantity of filter remaining
Remote control Control panel
See “Navigating through the menu” on page 34.
See “Main menu and Sub-menu” on page 32.
COMPUTER2 SELECT
NO SIGNAL SHUT-OFF
DISABLE
FG FG
15 MIN.
60 MIN.
FG FG
20 MIN.
55 MIN.
FG FG
25 MIN.
50 MIN.
FG FG
30 MIN. 45 MIN.
FG FG
35 MIN.
IH 40 MIN.
INITIAL START UP
Options Description
LAST MEMORY
Start as the same mode as the
last switched off.
STANDBY Always start in standby mode.
ON
Always start in projecting
mode.
