11
VQT4X66
ENGLISH
11
With this method you will share the wireless
network settings of your iPod touch/iPhone/iPad
with this system.
≥ The following explanations are based on an
iPhone.
1 Disconnect any devices connected to the CD
unit.
2 Connect the iPhone to your home wireless
network.
3 Connect the iPhone to the CD unit.
Choose one of the following connections.
“IPOD_DOCK” connection compatible iPod
touch/iPhone:
iPod touch/iPhone/iPad with iOS 5.0 or later:
Connect to the iPod port on the side of the CD
unit with a dedicated USB cable.
4 Unlock your iPhone and then press and hold
[sNETWORK SETUP] on the CD unit for more
than 3 seconds.
≥ If “NOT SUPPORTED” or “SET WI-FI” is displayed,
check that the iPhone is connected to the wireless
network and try again from step 1.
5 A message will pop-up on your iPhone. Allow
the iPhone to share the wireless network
settings.
*1
{. The Wi-Fi status indicator blinks.
6 The settings are completed when “SUCCESS”
is displayed and the Wi-Fi status indicator
stops blinking and lights in blue.
7 Press [OK] on the remote control to exit the
settings.
*1: Depending on the network environment or the wireless
network router settings, it may take more than 10 mins.
to complete the settings.
Method 2
If you're using an iPod touch/iPhone/iPad.
(iOS version 5.0 or later.)
If “FAIL” is displayed press [OK] and try the
setting again. If “FAIL” is still displayed, try other
methods on page 10 or 12.
≥ If the iPhone was disconnected midway through, try again
without disconnecting it.
SC-NE5GS~VQT4X66.book 11 ページ ２０１３年３月２５日 月曜日 午後３時４０分
