9
Quick Start
Guide
Accessories/Optional Accessory
A
A
Attaching the pedestal to TV
Fix securely with assembly screws
A
. (Total 4 screws)
Tighten screws firmly.
WARNING
Always be sure to ask a qualified technician to carry out set-up.
Incorrect fitting may cause equipment to fall, resulting in injury and product damage.
Do not disassemble or modify the pedestal.
Otherwise the TV may fall over and become damaged, and personal injury may result.
Caution
Do not use any other TV and displays.
Otherwise the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic
Dealer immediately.
During set-up, make sure that all screws are securely tightened.
If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be
strong enough to support the TV, and it might fall over and become damaged, and personal injury may result.
Foam mat or thick
soft cloth
Antenna terminal Pin terminals HDMI terminal
greenbluered
green
Firmly tighten by hand.
Match colors of plugs and terminals.
Insert firmly.
Insert firmly.
Reference of connection
Location
Place the TV at a comfortable distance for viewing. Avoid placing it where sunlight or other bright light (including
reflections) will fall on the screen.
Use of some types of fluorescent lighting can reduce remote control transmitter range.
Adequate ventilation is essential to prevent an internal component failure. Keep away from areas of excessive heat
or moisture.
15°
a
b
15°
TC-L32G1
a: 14.2” (359 mm)
b: 9.1” (230 mm)
TC-L37G1
a: 15.8” (399 mm)
b: 11.7” (295 mm)
Adjust the LCD panel
to your desired angle.
When this hole is aligned
with the center of the
groove, the pedestal
will be positioned at the
center of its rotation.
(View from above)
Note
Ensure that the pedestal does not hang over the edge of the base even if the TV swivels to the full rotation range.
Do not place any objects or hands within the full rotation range.
