6
Before Operating This Set
■
Battery Installation
The incorrect use of batteries can cause electrolyte leakage which will corrode the Remote Control or cause the
batteries to burst.
1
Open the cover.
Press bottom downward and pull out the cover.
2
Batteries: Use two “R6 (AA)” size batteries.
Insert the batteries ensuring correct polarity.
This is identifiable by the “+” and “–” symbols on both the batteries
and inside the battery compartment.
3
Replace the cover, and slide in reverse until the lock snaps.
Do not use rechargeable (Ni-Cd) batteries.
They are different in shape and performance and may fail to ensure correct operation.
!!
!!
Battery cautions
Two “R6 (AA)” size
Old Batteries New Batteries
Replacement both batteries at the same time. Don’t mix battery types
(alkaline with carbon, zinc etc.)
Don’t recharge.
TX32F500A-2912_E Page 6 Saturday, July 16, 2005 12:23 PM
