A SERVICE OF

logo

Using UServe and UClient 7-1
USING USERVE AND UCLIENT
To prepare the printer to run an application, you must copy the
application’s files to it from the PC. To do so:
1. Establish a connection between the printer and PC.
2. Copy files between the units.
Establishing a PC/Printer Connection
You must establish a connection between the PC and the printer using
the UClient and UServe software that runs on the PC and printer,
respectively. To establish this connection:
1. Connect the printer and PC with a cable (part number 124054).
2. Turn on the printer and type USERVE at the DOS prompt. You will
see:
USERVE 1.04 READY
_
7