9
English
Installation
Using the remote control
IMPORTANT!
– Remove the
protective plastic tab
before using the
remote control.
–Always point the
remote control directly towards IR area .
To replace the battery
1 Press and hold 1 as indicated
2 Simultaneously, pull the battery tray at 4
3 Remove the old battery and put a new CR2025
battery in place
4 Put back the battery tray
CAUTION!
– Remove the battery if it is exhausted
or will not be used for a long time.
– Batteries contain chemical substances,
so they should be disposed of properly.
Setting the clock
The time is displayed using the 12-hour clock.
1 On the set, press and hold CLOCK
➜ The hour digits start flashing (AM 12: 00 by
default)
2 Hold down or press ∞ or § repeatedly to set
the hour
3 Press CLOCK to confirm the setting
➜ The minute digits start flashing
4 Repeat step 3 to set the minute
5 Press CLOCK to confirm the setting
➜ The clock shows the set time
To turn on the Daylight Saving Time
(DST) mode
1 In the standby mode, press and hold DISP on
the set
➜ Current time setting moves ahead by 1 hour.
DSTappears
2 Press DISP again
➜ The set returns to normal time setting.
DSTdisappears
1
3
2
C
R
2
0
2
5
L
I
T
H
I
U
M
C
R
2
0
2
5
L
I
T
H
I
U
M
Perchlorate Material-special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/
perchlorate.
p001-p018_AJ6110_37-Eng 2008.10.17, 11:329
