Installation Instructions 3 - 7
3.5 OUTPUT CONNECTIONS
This section describes the followin
output connections:
• output channel terminals
• GPIB connector
•tri
er bus SMB connectors
3.5.1 Output channel connections
The number of the output channels of the various power supplies is indicated in
the last fi
ure of the model number (sin
le, dual or triple).
Every output channel connector is identical and consists of four terminals, i.e., two
Volta
e output terminals and two sense input terminals. A load can be connected
in one of the followin
ways:
• to the + and - volta
e terminals (local sensin
)
• to the + and - volta
e and sense terminals (remote sensin
)
WARNING: To prevent SHOCK HAZARD, turn off the power before makin
rear output channel connections. All wires and straps must be
properly insulated, and connected with terminal block screws
securely ti
htened. Before any connection can be made, the
plastic terminal block cover must be unscrewed and removed.
When the connections have been made, the plastic terminal
block cover must be reinstalled a
ain.
= PM2811 and PM2831 (sin
le)
= PM2812 and PM2832 (dual)
= PM2813 (triple)
OUTPUTOUTPUTOUTPUT
CHANNEL 1 CHANNEL 2 CHANNEL 3
- S- V+ V+ S
load
- S- V+ V+ S
load
(local sensin
) (remote sensin
)
