Using the tuner
07
45
En
Naming station presets
For easier identification, you can name your
station presets.
1 Choose the station preset you want to
name.
See Listening to station presets (this page) for
how to do this.
2 Press T.EDIT (TUNER EDIT).
The display shows ST. NAME, then a blinking
cursor at the first character position.
3 Input the name you want.
Names can be up to four characters long.
•
Use the MULTI JOG/INPUT SELECTOR
dial or ST +/– buttons (front panel) the }
and ] buttons (remote) to select
characters.
• Press ENTER to confirm a character.
If no character is input, a space is input.
• The name is stored when ENTER is
pressed after choosing the fourth
character.
To erase a station name, simply repeat
steps 1-3 and input four spaces instead of
a name.
Once you have named a station preset, you
can press DISPLAY when listening to a
station to switch the display between the
name and the frequency.
Listening to station presets
If you haven’t already stored some station
presets, see the previous page to do so.
1 Press TUN (remote) or use the MULTI
JOG/INPUT SELECTOR dial on the front
panel to select the tuner.
2 Press CLASS to select the class in which
the station is stored.
Press repeatedly to cycle through classes A, B
and C.
3 Press ST +/– (STATION +/–) to select the
station preset you want.
• If the receiver is left disconnected
from the AC power outlet for an extended
period, the station memories will be lost
and will have to be reprogrammed.
