QSC Audio CMX 2000V Manual

A SERVICE OF

next previous

13

14

Terminal Block Connector

The terminal block connector requires the following assembly.

1. Strip the wires to 7 ~ 8 mm.

2. Insert the wires into the male part of the connector according to the operating mode you are using. See (Figure 31).

3. Use a ﬂat-tip screwdriver to secure the wires. Tighten the screws to 6 in.-lbs.

4. Insert the plug into the receptacle on the ampliﬁer.

5. Use a ﬂat-tip screwdriver to secure the connector. Tighten the screws to 6 in.-lbs.

STEREO and PARALLEL INPUTS mode:

Wire as shown by loudspeaker symbols 1 and 2 on the back of the ampliﬁer, and as shown by the solid wires in the diagram.

BRIDGE MONO mode:

Wire as shown by BRIDGE MONO loudspeaker symbol on the ampliﬁer, and as shown by the dashed wires in (Figure 31).

Terminal Block Connector Wiring

UL IEC

Wire range - 6 mm

2

Solid wire (AWG) 28 – 10 -

Stranded wire (AWG/mm

2

) 28 – 10 -

Torque (lb.-in.) 6 -

Wire strip length 7 – 8 mm -

— Figure 31 —

— Table 3 —