Manual-3
Rear Panel Description
INPUTS 1 and 2: Choose between the balanced XLR or the balanced/unbalanced ¼" TRS jacks, but only use one. Inserting a ¼"
TS jack will work—however—we recommend using balanced lines, especially when connecting any cable over 10 feet (3 meters)
in length. Consult the Sound System Interconnection RaneNote provided with this manual.
INPUTS 1 and 2 Gain Trim Switch: In its +4 dBu position, the Input gain of the respective channel is unity. In the -10 dBV posi-
tion, the input gain is increased by 12 dB (although mathematically suspicious, it really is 12 dB, not 14 dB) to compensate for
certain recording devices. is switch must be in the +4 dBu position for front panel calibration accuracy.
OUTPUTS 1 and 2 are delivered by the balanced XLR or the unbalanced ¼" TS jacks. Using both types of Outputs are permissible
to drive two devices, such as an amplifier and a recorder. is device uses low impedance balanced line drivers. Do not connect the
XLR “+” or “–” output pins to ground, as this may cause the power supply to shut down. For unbalanced use, leave the unused output pin
(“+” or “–”) unterminated.
System wiring example for a DJ system
DC 22S STEREO COMPRESSOR
TTM 56S MIXER
AC 22S STEREO 2-WAY CROSSOVER
ME 15S STEREO EQUALIZER
OUTPUTSINPUTS
RIGHTLEFT
OUTPUTS
LEFT
INPUTS
RIGHT
LEFTRIGHT
RIGHTLEFT
LEVELLEVEL
010010
LEVELLEVEL
010010
STEREO AMP, HIGH
MONO OR BRIDGED AMP, MONO SUB
RIGHT SPEAKER
LEFT SPEAKER
MONO SUBWOOFER
WIRING
TIP / PIN 2 = POSITIVE
RING / PIN 3 = NEGATIVE
SLEEVE = SIGNAL GROUND
PIN 1 = CHASSIS GROUND
CHANNEL 1
OUTPUT INPUT
CHANNEL 2
OUTPUT INPUT
MADE IN U.S.A.
RANE CORP.
ME 15S
ACN 001 345 482
COMMERCIAL AUDIO
EQUIPMENT 24TJ
R
100-240 V
50/60 Hz 7 WATTS
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause
harmful interference, and (2) this
device must accept any interference
received, including interference that
may cause undesired operation.
ACN 001 345 482
INPUT
1
OUTPUT
1
BAL/UNBALBALANCEDBALANCED BAL/UNBAL
+4 dBu
-10 dBV
MADE IN U.S.A.
RANE CORP.
DC 22S
WIRING
3-PIN XLR:
• PIN 2 = (+), • PIN 3 = (–),
• PIN 1 = CHASSIS (SHIELD)
1/4" PHONE, BALANCED:
• TIP = (+), • RING = (–),
• SLEEVE = CHASSIS (SHIELD)
1/4" PHONE, UNBALANCED:
• SEE THE RANENOTE: SOUND
SYSTEM INTERCONNECTION
100-240 V
50/60 Hz 7 WATTS
COMMERCIAL AUDIO
EQUIPMENT 24TJ
R
This device complies with Part
15 of the FCC Rules. Operation
is subject to the following two
conditions: (1) this device may
not cause harmful interference,
and (2) this device must accept
any interference received,
including interference that may
cause undesired operation.
INPUT
2
OUTPUT
2
BAL/UNBALBALANCEDBALANCED BAL/UNBAL
+4 dBu
-10 dBV
ACN 001 345 482
LOW OUTCH 1 IN
3-WAY IN
MONO SUB OUTMONO
LOW OUT
HIGH OUT
STEREO 2-WAY
SUBWOOFER SWITCH MUST
BE SET TO 2-CHANNEL
FOR MONO 3-WAY
CH 2 INLOW OUT
2-CHANNEL
SUBWOOFER
MONO SUB
OMIT MONO
MONO 3-WAY
MODE
OMIT MONO
MONO SUB: OMIT
MID OUT
HIGH OUT
HIGH OUT
MADE IN U.S.A.
RANE CORP.
AC 22S
PIN 2: POSITIVE
PIN 3: NEGATIVE
PIN 1: CHASSIS GND
100-240 V
50/60 Hz 7 WATTS
COMMERCIAL AUDIO
EQUIPMENT 24TJ
R
This device complies with Part
15 of the FCC Rules. Operation
is subject to the following two
conditions: (1) this device may
not cause harmful
interference, and (2) this
device must accept any
interference received,
including interference that may
cause undesired operation.
AUX
PHONO
GROUNDS
POWER
PGM 1PGM 2
4321
4
4
3
3
2
2
1
1
4321
100-240V
50/60 Hz
20 WATTS
ACN 001 345 482
MADE IN U.S.A.
RANE CORP.
U.S. PATENT 6,813,361
OUTIN
OUTIN
MIC
BALANCED
MASTER
OUTPUTS
R
L
R
L
R
L
R
L
R
L
R
L
LINE
PHONO
TTM 56S
COMMERCIAL AUDIO
EQUIPMENT 24TJ
R
EFFECTS
SEND
UNBALANCED
FlexFX
RETURN
TIP = SEND
RING = RTN
BALANCED
ACN 001 345 482
INPUT
1
OUTPUT
1
BAL/UNBALBALANCEDBALANCED BAL/UNBAL
+4 dBu
-10 dBV
MADE IN U.S.A.
RANE CORP.
DC 22S
WIRING
3-PIN XLR:
• PIN 2 = (+), • PIN 3 = (–),
• PIN 1 = CHASSIS (SHIELD)
1/4" PHONE, BALANCED:
• TIP = (+), • RING = (–),
• SLEEVE = CHASSIS (SHIELD)
1/4" PHONE, UNBALANCED:
• SEE THE RANENOTE: SOUND
SYSTEM INTERCONNECTION
100-240 V
50/60 Hz 7 WATTS
COMMERCIAL AUDIO
EQUIPMENT 24TJ
R
This device complies with Part
15 of the FCC Rules. Operation
is subject to the following two
conditions: (1) this device may
not cause harmful interference,
and (2) this device must accept
any interference received,
including interference that may
cause undesired operation.
INPUT
2
OUTPUT
2
BAL/UNBALBALANCEDBALANCED BAL/UNBAL
+4 dBu
-10 dBV
