Rear panel of the set
Side panel
of the set
2.5mm Stereo Cable
(cross data cable)
USB Cloner
1. Turn TV on.
2. Connect USB Cloner to TV USB Port.
3. Set switch to “learning” position.
(Status LED will Light red without flashing.)
4. Connect 2.5mm Stereo Cable (cross data cable)
between the TV service port and the USB Cloner
service port.
5. Press the Learn button for 1 second. As soon as
the LED turns green, release the button.
6. The LED will turn Red and flash while the settings
are being saved to the USB Key. Upon successful
copy, the LED will light up yellow for 2 seconds
and then return to a red, constantly lit state.
Upon an unsuccessful copy, the LED will flash an
error code as described in the “Error Table” sec-
tion.
Note :New TV Settings file, “ChList.bin” will appear
on the USB Cloner .
Learning - 26/32 inches
1. Turn TV on.
2. Connect USB Cloner to TV USB Port.
3. Set switch to “learning” position.
(Status LED will Light red without flashing.)
4. Connect 2.5mm Stereo Cable (cross data cable)
between the TV service port and the USB Cloner
service port.
5. Press the Learn button for 1 second. As soon as
the LED turns green, release the button.
6. The LED will turn Red and flash while the settings
are being saved to the USB Key. Upon successful
copy, the LED will light up yellow for 2 seconds
and then return to a red, constantly lit state.
Upon an unsuccessful copy, the LED will flash an
error code as described in the “Error Table” sec-
tion.
Note :New TV Settings file, “ChList.bin” will appear
on the USB Cloner .
