E
21
1-4. Basic System Installation
Perform the following steps to install your system.
●
Take the monitor out of the packaging box.
●
Place the monitor where you would like to install it. Do not turn on power until
installation is complete
●
Choose the place where you want to install the camera.
●
Once the monitor and camera locations have been chosen, install the camera.
●
Connect the cable to the jack on the back of the camera.
●
Connect the other end to CAMERA IN on the back of the monitor.
(At this time, select the numbers and sequence of cameras.)
●
Connect the camera you wish to install (as shown below).
●
Connect the power cord of the monitor to the power outlet.
●
Power switch is on the rear panel of the monitor, and screen on switch is on the front
panel of the monitor.
●
Initially the monitor is in the auto switching mode.
✳ After the power has been turned on, the CRT needs approximately 20 seconds of
stabilization period.
