Computer Input
25
Choose Computer 1 or Computer 2 by pressing the
COMPUTER button on the remote control. Before
using this button, correct input source should be
selected through Menu operation as described below.
Input Source Selection
Direct Operation
Remote Control
COMPUTER button
Input Menu
Move the pointer (red
arrow) to Computer 1 and
press the SELECT button.
Input Menu icon
Move the pointer to RGB
and press the SELECT
button.
Source Select Menu
Computer
1
Press the MENU button to display the On-Screen
Menu. Press the Point ◄► buttons to move the
red framed pointer to the Input Menu icon.
1
Press the Point ▲▼ buttons to move the red
arrow pointer to either Computer 1 or Computer
2, and then press the SELECT button.
2
After the Source Select Menu appeared for
Computer 1, move the pointer to RGB and then
press the SELECT button.
3
Menu Operation
Note:
• When the Input Search function is set On1
or On2, the input signal will be searched
automatically. (p.45)
• Computer 2 is not displayed when the COMPUTER IN 2
/ MONITOR OUT terminal is set as Monitor out. (p.45)
• Computer 2 (COMPUTER IN 2 / MONITOR OUT) can
accept only RGB signal.
Input Menu
Move the pointer to
COMPUTER 2 and press
the SELECT button.
Computer 1
Computer 2
See Note at the bottom of this page.
