Assembly
Parts
• Main Unit (from Step 2)
• #4 - Water Bottle Holder
(Two parts: (4a) outer ring, (4b) - base)
• #6 - Console Mast (Qty. 1)
• #21 - Mast Boot (Qty. 1)
Hardware
• #24 - M8 Flat Washer (Qty. 5)
• #25 - M8 Lock Washer (Qty. 5)
• #26 - M5x25 Phillips Head Screw (Qty. 2)
• #29 - M8x15 Hex Screw (Qty. 5)
Tools
• Phillips Head Screwdriver
3-1 Put the Console Mast into the Mast Boot.
3-2 Connect the wire harness (W1) from the Main Unit to the
wire harness (W2) in the Console Mast.
3-3 Move the Console Mast down on the Main Unit. Secure
the Console Mast with the hardware shown.
NOTICE: Do not pinch the wires when putting the
Console Mast on the Main Unit.
3-4 Move the Mast Boot down to the Main Unit.
3-5 Attach the Water Bottle Holder to the Console Mast with
the hardware shown.
Step 3: Install Console Mast and Water Bottle Holder
Assembly Manual
10
