14
ECO menu
[
3hr.
]
MENU
[
ECO
]
No operation off
Ecology
Option
Power management
4
Setup
[
Enable
]
No signal off
ECO
■ No signal off
You can set the TV to automatically power off in about
15 minutes after the TV goes into a state of receiving no
programme signals, such as the end of a broadcast day
(Enable, Disable).
• Five minutes before the power shuts down, the remaining
time displays every minute.
NOTE
• “Disable” is the factory preset value.
• When a TV programme finishes, and the TV receives signal
input, this function may not operate.
■ Power management (PC input mode only)
You can set the TV to automatically power off when no
image is displayed on PC.
Selected item Description
Off
• No power management
• Factory preset value.
Mode1
• If no signal inputs for approximately
• 8 minutes, the power shuts down.
• Even if you start using the PC and the
signal inputs again, the TV stays off.
• The TV turns on again by pressing
POWER (See page 9).
Mode2
• If no signal inputs for approximately
• 8 seconds, the power shuts down.
• When you start using the PC and the
signal inputs again, the TV turns on.
• The TV turns on again by pressing
POWER (See page 9).
■ No operation off
You can set the TV to automatically power off when no
TV operation is performed for more than 3 hours
(30 min., 3 hr., Disable).
• Five minutes before the power shuts down, the remaining
time displays every minute.
NOTE
• “Disable” is the factory preset value.
■ Ecology
When set to “Yes”, the TV activates the following power
saving mode.
• “OPC” set to “On” (Page 13).
• “No signal off” set to “Enable” (Page 14).
• “Power management” set to “Mode1” (Page 14).
• “No operation off” set to “3 hr.” (Page 14).
• “Quick start” set to “Off” (Page 16).
NOTE
• Ecology mode cannot be deactivated by selecting “No”. Each
setting must be changed individually to deactivate Ecology
mode.
Setup menu
MENU
[
Setup
]
Auto installation
Analogue programme setup
Digital programme setup
Input skip
Input label
4
4
Position
4
Text language
Identification
Reset
[
On
]
[
Panorama
]
[
Off
]
[
West Europe
]
Setup
Option
HDMI auto view
WSS
4:3 mode
Quick start
Child lock
Digital setup
■ Child lock (ATV and DTV input mode only)
Allows you to use a password to protect certain settings
from being accidentally changed.
Setting a password
1 Repeat steps 1 to 2 in Menu operation.
2 Press a/b to select “Child lock”, and then press
ENTER.
3 If you already set the password, enter it here.
4 Press a/b to select “Change password”, and
then press ENTER.
5 Enter the 4-digit number as a password using 0
— 9.
New password
– – – –
Reconfirm
Change password
Clear password
Parental rating
– – – –
Enter your new password. Use 4 digits
6 Enter the same 4-digit number as in step 5 to
confirm.
NOTE
• To view a locked channel (Lock setting in Analogue
programme setup “Manual adjust” is set to “On”), you must
enter a password. When you select a locked channel, “Child
lock has been activated” is displayed.
• Press ENTER to display the password input window.
Clearing the password
Allow you to clear your password.
1 Repeat steps 1 to 3 in Setting a password.
2 Press a/b to select “Clear password”, and then
press ENTER.
3 Press c/d to select “Yes”, and then press
ENTER.
