![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/b/ba/bba595b4-d00d-4205-a4b0-d52fefca9349/bba595b4-d00d-4205-a4b0-d52fefca9349-bg1c.png)
28
ENGLISH
• Each adjustable range of bass and treble is -10~+10.
• In general, we recommend the bass and the treble to
be set to 0(flat) level.
• At “TONE ON” mode, you can select “TONE OFF”
mode and vice versa.
TONE ON: When adjusting the tone for your taste.
(“DIRECT” indicator goes off.)
TONE OFF: When listening to a program source
without the tone effect.
(“DIRECT” indicator light up.)
• When using this function with remote control unit,
press OSD button and refer to page 38~40.
Notes:
• If the display of the corresponding mode disappears, start from the step 1 again.
• Extreme settings at high volume may damage your speakers.
• When the digital signals from DTS, Dolby Digital or MPEG program sources are input in available surround
mode, you cannot adjust the tone and can hear a program source without the tone effect.
While displaying the desired tone mode,
adjust the tone as desired.
3
Compressing the dynamic range (Dolby Digital sources only)
• This function compresses the dynamic range of previously specified parts of the Dolby Digital sound track(with
extremely high volume) to minimize the difference in volume between the specified and non-specified parts.
This makes it easy to hear all of the sound track when watching movies at night at low levels.
• Only when the digital signals from Dolby Digital program source are input in available surround mode, the
dynamic range can be adjusted.
Press the SETUP button for more than 2
seconds, then it enters the setup mode.
While displaying the setup mode, press this
button short repeatedly until “DYNR 0.0” is
displayed.
1
• Each time the ADJUST UP(
) or DOWN( ) button is pressed, the mode
changes as follows:
DYNR 0.0 : Off
DYNR 0.5 : Low compression
DYNR 1.0 : High compression
• When using this function with remote control unit, press OSD button and refer to
page 38~40.
Notes:
• If the display of the dynamic range mode disappears, start from the step 1 again.
• In some Dolby Digital softwares, this function may not be available.
While displaying “DYNR 0.0”, select the desired mode.
2