• To emphasize the deep bass sounds, connect a powered
subwoofer.
Note :
• When the power amplifier is assigned to “SB+W” (Surround
Back+Subwoofer), no signals are output from the
SUBWOOFER PRE OUT jack. (For details, refer to “When
selecting the AMP ASSIGN” on page 35.)
6. CONNECTING SUBWOOFER PRE OUT
• Connect this jack to the DIG-LINK jack of the external
Sherwood component that uses the DIGI LINK II or III remote
control system.
Note :
• The DIGI LINK operation may not work on some Sherwood
components.
7.
CONNECTING DIGI-LINK
• Be sure to connect speakers firmly and correctly according to
the channel (left and right) and the polarity (+ and -). If the
connections are faulty, no sound will be heard from the
speakers, and if the polarity of the speaker connection is
incorrect, the sound will be unnatural and lack bass.
• For installing the speakers, refer to "Speaker placement" on
page 9.
• After installing the speakers, first adjust the speaker settings
according to your environment and speaker layout. (For details,
refer to "SETTING THE SPEAKER SETUP" on page 39.)
Surround back speakers
• When using only one surround back speaker, you should
connect it to SURROUND BACK LEFT channel.
In this case, you can connect a subwoofer without built-in
amplifier to the SURROUND BACK RIGHT channel. (For details,
refer to “When selecting the AMP ASSIGN” on page 35.)
Caution :
• Be sure to use the speakers with the impedance of 6 ohms or
above.
• Do not let the bare speaker wires touch each other or any
metal part of this unit. This could damage this unit and/or the
speakers.
8. CONNECTING SPEAKERS
ENGLISH
