Figure 8. Upper
UaSn
I _
29. Align the steering wheel and push down onto shaft.
30. Reinstall capscrew (C, figure
7),
flat washers, and
locknuts to secure steering wheel. Torque nut to 10 ft.
Ibs.
31. Reconnect throttle cable to engine and position
under manifold
capscrew and washer. Cable must be
in original position for correct RPM setting. Tighten
capscrew and place cable in left-side engine clamp.
32. Push throttle control knob back on the lever. Tap
knob with a hammer to seat.
33.
Make sure the fuel lines are connected securely to the
fuel filter with the clamps.
34. Install the rear right-band wheel assembly.
35. Raise rear of tractor up and rembve
jackstand
36. Connect the battery cables
-
negative cable last.
37. Apply the decal to the right side of the switch.
38. This completes the installation.
I
I
5-.
REAR-MOUNTED ATTACHMENTS
-
LIFT ROD INSTALLATION
Lift rod (L, figure 1) is used only for rear mounted
attachments. To install, remove bottom clevis pin (Q)
and install lift rod (A, figure 9) to actuator link(B) and lift
arm (C). Secure with clevis pins (D) as shown.
Figure 9. Lift Rod
A. Lift Rod
6.
Actuator Link
C. Lift Arm
D.
Spring Clips
~
