Step 4; See Figure 4:
Install right & left Front Posts (5) and right & left
Top Frame Braces (6 & 7).
Note: Bent ends of Top Frame Braces will point
rearwards and lay flat when properly installed.
A. Insert a 1/4” x 3/4” bolt forward through the
tab on the post, the end of the Front Panel
Frame and then the lower end of the Top Frame
Brace. Add a nut. Tighten just enough to hold
the braces up.
B. Insert a 1/4” x 3/4” bolt outwards through the
lower hole in the foot, the lower hole in the post
and then the right Foot Pocket Guard (shorter
than left). Add a nut. Tighten enough to hold
the Foot Pocket guard as shown.
C. Insert a bolt out through the upper hole in
the Foot and Post. Place a door hinge from the
Door Hardware Package over the bolt and add
a nut. Do not tighten at this time.
D. Repeat on left side of tractor.
Figure 4
Figure 5
Step 5; See Figure 5:
Install Rear Cross Bar Brackets (8) and Rear
Cross Bar (9)
A. Remove the bolts at Reference B.
B. Place the Rear Cross Bar Brackets over the
holes as shown. Replace the bolts. Do not
tighten at this time.
C. Place the tabs welded to the Rear Cross Bar
over the brackets as shown. Insert two bolts
down through the holes and add locknuts. Do
not tighten at this time.
7
